Copyright © 2011 Shenzhen C2S Technology Co., Ltd. All rights reserved.
connection. If IP1 is not available or not reachable, it will switch to use IP2 IP address for
data sending as backup.
• Port1(2):
This is destination server port number to which FL-2000G is sending data using GPRS.
FL-2000G support device configure two Ports. Port1 is for IP1 only, and Port 2 for IP2
only. The priority is same as the IP address.
• Device ID:
The device ID is the unique identification code which was registered in Server database.
Only those registered devices will be allowed to send data over sever, otherwise their
connection will be kicked out.
In C2STEK Tracking Server, FL-2000G device has been requested to use IMEI No as device
ID only. But the FL-2000G device firmware also allows you to input another self-defined
Numbers as device ID if your application need.
6.1.3 Authorization Setting
In this authorization setting is defined those authorized Phone NOs. which allow to remote
access device by SMS commands, or receive alarm alerts from device.
•User A/B/C:
These 3 authorized No. are allow to receive Alarm alerts by SMS or missed calls from
FL-2000G device. And they also could call device Simcard directly to get into "Voice Listen-in"
mode.
•Call Center D:
This D phone No. is defined for monitoring base Emergency Call service No. By press the
device shortcuts call button, and the device will automatically call this phone NO. to open an
intercom between monitoring base and Driver
•Server SMS G:
G is used for monitoring base SMS modem No, which use to send SMS to device from server
or receive SMS from device to Server.
