C-SCOPE Newforce R1, Operating Instructions Manual

Page: 13 / 27

12
This allows the operator to select which settings are restored when the R1 is switched on.
Highlight the desired choice using the MENU/SCROLL control and then press the ENTER
button.
DEFAULT (setting)
This will tell the R1 to load the factory default settings every time it is switched on.
LAST
(setting)
If MANUAL mode is selected (see below) this will tell the R1 to switch on with exactly the
same settings as when it was last used. This enables you to turn the R1 off when digging for
deep targets and then switch it back on and resume your searching without having to
readjust the detector.
MANUAL
OFF
This turns the manual mode off so when you turn on the R1 you are presented with a short -
cut to the easy to use manufacturer defined programs of:
COIN INLAND
for general purpose searching on
most sites i.e. those not affected by very high
mineralisation or salt deposits.
ALL METAL for very deep searching of all metals
(no discrimination).
COIN BEACH
for general purpose searching on
the beach or highly mineralised sites.
MANUAL
ON
This turns the opening selection screen off so that when you turn on the R1 you are
immediately in the searching mode. Experienced users of the R1 may prefer this setting.
RECALL
DISCRIM GR’ND TYPE COIN INLAND
SENSITIVITY OPTIONS ALL METAL
AUDIO RECALL COIN BEACH
PROGRAMS STORE USER 1
SET UP BACK USER 2
Recalls all settings from the program selected from the list (see also MANUAL OFF above).
STORE
DISCRIM GR’ND TYPE USER 1