Note: We recommend professional fitting by an approved
professionals so as to ensure no mistakes are made, as there
require holes to be cut in the rear bumper or bodywork.
Installation
①
Install Sensors
a. The recommended height to install sensors is 50cm to 60cm for
bumpers vertical to the ground or a little bit upward-angled. Mark
positions according to following suggestions.
123456
1/8L
1/4L
1/4L
1/4L
1/8L
L
50
-60cm
Vertical
123456
1/4L
1/2L
1/4L
L
Vertical
50
-60cm
Note:
In case lower than 50cm or downward angled bumper
installation is required, contact us for specific instructions.
4 sensors
2 sensors
c
Use the right size hole saw to cut holes
.
.
.
.
.
d
Deflash the hole by a cutter
Insert the sensor and make sure the '
' is up.
e
Position Rib
UP
Remarks:
1.If there is position rib on the sensor, a file is needed to make the
position groove;
Position groove must
be on the top or bottom.
4
5
b Manually make a position point by pointed tool to prevent
electric drill from sliding during drilling
.
.
Make sure the
arrow is up
After Installation
the sensors fit
the bumper well
2.For metal bumper installation, Plastic Sleeve is needed
Position groove
Step 1. Drill a 26mm
hole and file a groove
Step 2. Insert the plastic
sleeve
Step 3. Insert the 22mm sensor
Plastic sleeve
