4.2 Resetting the Gateway
Write the “RST_DEVICE” Gateway Coil (Function Code
address = 2, Raw Address = 1) to TRUE. The device will
reset one second after receiving this command. This
resets all wireless device data in the FRR. Additionally,
if any gateway settings (baud rate, MODBUS address,
communication mode) were modified, this causes these
settings to take effect.
4.3
Resetting the Wireless Network
Write the “RST_WNET” Gateway Coil (Function Code
address = 3, Raw Address = 2) to TRUE. The gateway will
take approximately 30 seconds to complete the wireless
network reset after the acknowledging this command. No
serial commands will be acknowledged during this time
(wired LED is red). This operation optimizes the RF
configurations for best performance and clears out all
devices from the WDL. The gateway will not be active
until at least one wireless device is registered.
4.4
Resetting to Default Communications Settings
Write the “RST_COM” Gateway Coil (Function Code
address = 4, Raw Address = 3) to TRUE. After setting this
coil to true, a device reset command must be issued (or
power cycling) before any of the new settings will take
effect.
Resets the baud rate, mode, and device ID back to defaults,
which are respectively: 19200, RTU: 8-N-1, 95.
4.5 Resetting the Gateway to Factory Settings
Write the “RST_FACTORY” Gateway Coil (Function Code
address = 5, Raw Address = 4) to TRUE. After setting this
coil to true, the device will reset automatically one second
after the write coil command is acknowledged. No manual
reset is required.
- 13 -
