4
Installation on PRETTY unit
Cut off the mains power supply before carrying
out any operation.
Remove the protective casing from the gear-
motor with the control station (PRETTY.A)
following the instructions supplied with the
PRETTY unit.
Install the batteries using the relative bracket
and screws as shown in the fi gure:
On the battery charger, re-
move the screw on the side
opposite the terminal board.
Disconnect the battery charger connector
(shown in the fi gure) from the control station’s
cover:
Using the screw supplied, install the battery
charger as shown in the fi gure:
Connect the batteries and the battery charger
as described in the “Connections” section.
Close the gearmotor assembly following the
instructions supplied with the PRETTY unit.
TCIC 3,5x9,5
TCIC 3,5x16
