BYOC Soaring Skillet, Instructions Manual

Page: 8 / 43

IMPORTANT BUILDING NOTES
Please make sure to follow these instructions step by step. There are
components that must be soldered into place before the opto couplers
are to be mounted onto the PCB. There will not be access to these
afterward, so avoid unnecessary de-soldering by following these
instructions carefully.
Note about the resistors: Most of the resistors in your kit will be 1/8
watt (small resistors), but your kit may contain some ¼ watt resistors
(regular sized resistors). The resistor spaces on your Soaring Skillet
PCB will be for 1/8 watt resistors. If your kit contains any ¼ watt
resistors, you should bend the lead on one side (either side. Resistors
are not polarized, so it does not matter) and stand them on end as
shown in the diagram below.