BYOC Soaring Skillet, Instructions Manual

Page: 20 / 43

STEP 8: Add the optocouplers.
Insert the optocouplers into the PCB so that the side with the gray dot is
facing up. Orient the optocoupler so that the gray dot is pointing towards the
positive (+) eyelet. The lead that goes in the positive (+) eyelet highlighted
in red, should be slightly longer. The shorter lead goes in the eyelet
highlighted in green. Insert the 3 element leads on the opposite side of the
optocoupler into the eyelets highlighted in purple. Make sure that the center
element lead goes in the center element eyelet. Remember that once the