These will be used to connect lugs/eyelets 4 with the longer 1/2 stripped ends being
used to jumper lugs 4 to 9 of both footswitches.
·
Cut 3 x 2 pieces of wire. Strip 1/4 off each end. These will be used to connect the
tip and sleeve of the IN jack and the tip of the OUT jack to the PCB.
·
Cut 1 x 1.5 peice of wire. Strip 1/4 off each end. This will be used to connect the
ring of the IN jack to the ring eyelet on the PCB.
Step 3: Solder the wires for the footswitch.
Step 4: Remove the PCB assembly from the enclosure. Solder the open ends of the wires
that you just soldered to the footswitch to their respective eyelets on the PCB. Load the
wires in from the top and solder on the bottom side.
Step 5: Reinstall the PCB assembly to the enclosure. Install the footswitch to the
enclosure. It will have a white nylon washer and a silver metal washer. You can decide
which washer you want to be visible on the outside of the enclosure.
Step 6. Solder the jacks to the PCB.