Before you get started....
There are a two things about this particular build that you should be aware
of so that you don't get confused when you compare the parts list to the layout on
the PCB.
1. There is a 2.2M resistor that will be inserted into the PCB so that it is standing on end
rather than laying flat like all the other resistors. The PCB will have a “2M2” printed on
it with an arrow pointing to the eyelets on the PCB where this resistor will go. (see page
10 - 11 for instructions)
2. There is an 8 pin dual op amp that goes on the bottom of the PCB.
