BYK micro-TRI-color, Operating Instructions Manual

Page: 27 / 56

BYK-Gardner GmbH Measure | 5
300 100 114 E 2103 micro-TRI-color 27
5 Measure
The measure function is accessible via the Measurement icon in the main menu.
The instrument provides two ways to perform measurements.
• Measure without Worklist [ } 27]
•
Measure with Worklist [
} 28]
Both scenarios are explained below.
The instrument is available in two variants:
• With display of values after each measurement,
see Displayed Values [ } 31]
• Without display of values after each measurement
In both cases, the measurement values are stored in the instrument memory.
You can browse and delete measurement values using the Browse icon accessible
via the main menu, see
Browse [
} 33] .
Number of Measurements
The number of single measurements during a sample reading depends on your
customization of the firmware. Default number of single measurements is three.
Measurement results are average values of single measurements.
5.1 Measure without Worklist
1. Open the snap closure.
2. Click on the Measurement icon in the main menu and place the instrument
on the sample.
3. The screen below is displayed. The four circles in the corners represent the four
pins on the bottom of the instrument. Green colored circles indicate pressed
pins, while red colored circles indicate not pressed pins. At least three circles
needs to be green (three pins must be pressed).
Illustration 24: Green colored circles indicating pressed pins
4. Click on the instrument icon in the middle of the screen or press the button
Operate to start the measurement.
5. The measurement is carried out. In order to go on with the next measurement,
lift the instrument and replace it on the sample again. Again, at least three cir-
cles needs to be green (three pins must be pressed).