Bygg-Ström LUX C12, User Manual

Page: 5 / 30

Manual Code - MI400A00105 Revision Level 00 - 09/09/2019
5

Use jumper cables only. Improper use can result in severe damage and safety risk.

NEVER use the machine if insulation on electrical cord is cut or worn through.

NEVER operate lights without protective lens cover in place or with a lens cover that is cracked or damaged!

Only authorized and trained personnel is allowed to perform the machine maintenance.
Please read the operator's manual and maintenance manual before using or servicing the machine.

HIGH VOLTAGE! This equipment utilizes high voltage circuits. Always exercise extreme caution when trouble shooting or
repairing any electrical circuit.

Only a qualified electrician should troubleshoot or repair electrical problems occurring on the machine.

Disconnect electrical power before removing protective covers on high voltage electrical closures.

NEVER allow water to accumulate at the base of the machine. If water is present, DO NOT service!

DO NOT service electrical components if your clothing or skin is wet.

Never wash the unit with a high pressure hose or with any kind of power washer.

Check and replace all missing and hard ‐ to ‐ read labels.

Make sure slings, chains, hooks, ramps, jacks, and other types of lifting devices are attached securely and have enough
weight ‐ bearing capacity to lift or hold the equipment safely.
For operators’ safety, the grounding of the machine always needs to be done paying attention on the section of the
cable to be used (never to be less than 10 mm2). For the connection of the grounding cable, please always use the clip
located on the control panel.
SAFETY RULES
ELECTRICAL HAZARD
SERVICING
EARTHING