Bygg-Ström LUX C12, User Manual

Page: 15 / 30

Manual Code - MI400A00105 Revision Level 00 - 09/09/2019
15
Before operating the unit, we suggest making the following routine checks for improved safety, better efficiency, longer
product life and in order to avoid work disruptions.

Check that the machine is leveled correctly and stabilized firmly.

Check that all the lamp lenses are clean and undamaged.

After adjusting the lights, prepare to raise the tower by:

Inspecting the cable and replacing it, if damaged.

Checking mounting hardware for proper tightness and re ‐ torquing if necessary.

Raise the mast and insert the safety pin supplied in the appropriate hole, see picture.

Ensure that all the electrical cables are undamaged and correctly connected.

Check that the main switch and the lamps switches are in the OFF position.

Drive the earth picket into the ground (earth) following any risk assessment. (*)

Check that the grounding cable is securely attached to the unit.

Open the frontal door to access the control panel.
For operators’ safety, the grounding of the machine always needs to be done paying attention on the section of the cable
to be used (never to be less than 10 mm2). For the connection of the grounding cable, please always use the clip located
on the control panel, on the right side of the machine. Always perform grounding operations in compliance with
local/international regulations.
LIGHTING TOWER USE
PRELIMINARY CHECK