background image

EN

4.3  Qualified personnel

Only authorised, trained persons and professionals shall install, commission and maintain the 

 filter  system.

 

Authorised, trained persons have obtained instructions regarding the assigned tasks and 

 possible risks in case of misuse or improper operation.

 

Professionals are in a position to install, commission and maintain the device, as a result 

of their technical training, knowledge and experience, as well as knowledge of applicable 

 regulations.

4.4  Pressure

CAUTION!

 

f

If the maximum nominal pressure exceeds 8 bar (116 psi) a pressure reducer must be installed upstream of the filter system.

 NOTE!

 

f

Installing a pressure reducer can reduce the flow.

 

f

The inlet pressure of the filter system should be higher than 1.2 bar (17.4 psi).

Pressure surges are to be avoided. If they do occur, the sum of pressure surge and idling 

 pressure must not exceed the nominal pressure of 8 bar (116 psi). The positive pressure surge 

must not exceed 2 bar (29 psi) and the negative pressure shock must not fall below 50% of the 

settling flow pressure (see DIN 1988 Part 2.2.4).

4.5  Operation after a break or shutdown / Replacement intervals

In the event of longer breaks in operation, close the shut-off valve in the inlet of the filter system. 

After a break in operation exceeding two days (weekends, vacation, ...), rinse the filter system 

with 4-5 litres (1.1-1.3 gallons) of water before reuse.

Replace the filter cartridge ...

 

on reaching the capacity stated in Section 3.2.

 

no later than 6 months after installation.

 

after a shutdown of 4 weeks or more.

4.6  Disposal

Dispose of exhausted filter cartridges, surplus parts and packaging according to local 

 regulations. If local collection points are available, recycle all product components to protect the 

environment.

5  Installing the filter system

 NOTE!

 

f

Decarbonized water contains free carbonic acid. Only appropiate materials are to be used for installation. Original BWT accessoiries are 

recommended.

5.1  Unpacking the filter system

Remove the filter system from the packaging. Inspect the delivery for completeness and 

 transport damage. Defective parts must be replaced immediately.

CAUTION!

 

f

Faulty or defect parts must be replaced immediately.

 

f

Always ensure a safe and clean working environment.

MMWPC_NeuesDesign_pink.indd   13

05.10.2018   08:43:48

Summary of Contents for AQA drink Magnesium Mineralized Water Protect MP400













Reviews: