Setting the Time of Day
1.
Press and hold either the Up or Down buttons until the programming icon replaces the
service icon and the parameter display reads TD.
2.
Adjust the displayed time with the up or down button.
3.
When the desired time is set, press and release the Extra Cycle button to resume normal
operation. The unit will also return to normal operation after 5 seconds if no buttons are
pressed.
Regeneration Options:
Queuing a Delayed Regeneration
1.
Press and release the Extra Cycle button once. The service icon will flash to indicate that
the regeneration is queued to occur at the next selected regeneration hour.
2.
To cancel a queued regeneration, press and release the Extra Cycle button again. The
service icon will stop flashing.
Regenerating Immediately
Press and hold the Extra Cycle button for five seconds.
1. The timer advances to Regeneration Cycle Step #1 (backwash), and begins
programmed time count down.
Default Factory set at 14 minutes.
2. Press and release the Extra Cycle button once to advance valve to Regeneration
Cycle Step #2 (brine draw & slow rinse).
Default Factory set at 40 minutes
3. Press and release the Extra Cycle button once to advance valve to Regeneration
Cycle Step #3 (rapid rinse).
Default Factory set at 1 minute
4. Press and release the Extra Cycle button once to advance valve to Regeneration
Cycle Step #4 (brine refill).
Default Factory set at OFF
Press and release the Extra Cycle button once more to advance the valve back to in service.
NOTE:
Any regeneration cycle step can be advanced to the next step by pressing and
releasing the cycle button
6
Summary of Contents for PROFESSIONAL II Series
Page 15: ...NOTES...
