441-HH-1
4
RELAY PROGRAMMING
Please read through these instructions completely before beginning programming procedure!
All transmitters are set to operate Relay 1 in the remote receiver by default. The relay to be operated can
be changed at any time by following the procedure below. Once changed, we recommend labeling the
transmitter with the selected relay number. If unsure of which relay the transmitter is set to operate,
follow steps 1 thru 6 below. Relay settings will not be changed during normal battery replacement.
To view which Relay unit is set to operate:
1. Remove the battery cover from the back of the transmitter.
2. Remove ONE of the batteries from the holder (be sure to note polarity so it is re-inserted properly
in the following steps).
3. Using one hand, depress and hold down Button 1 on the transmitter. While holding button down,
re-insert the battery into the holder.
4. With Button 1 still depressed and battery in holder, keep the button pressed for 5 seconds until
the LED turns
RED.
5. Keep holding Button 1 in until the LED turns
GREEN
.(about 3 more seconds).
6. Release button and wait while the LED stays GREEN for about 8 seconds, goes out, then begins
to blink. The LED will then blink
GREEN
the number of times equal to the relay number it is set to
operate.
To select the Relay you wish to operate:
1. Remove the battery cover from the back of the transmitter.
2. Remove ONE of the batteries from the holder (be sure to note polarity so it is re-inserted properly
in the following steps).
3. Using one hand, depress and hold down Button 1 on the transmitter. While holding button down,
re-insert the battery into the holder.
4. With Button 1 still depressed and battery in holder, keep the button pressed for 5 seconds until
the LED turns
RED.
5. Keep holding Button 1 in until the LED turns
GREEN.
(about 3 more seconds).
6. Release button and quickly press the number of times equal to the relay number you wish to
operate.
7. Once you stop pressing for three seconds, the LED will blink back
GREEN
the number of times of
the relay it’s now controlling to confirm your selection.
8.
If you didn’t make the proper relay selection, you must repeat the procedure beginning at Step 3.
You may repeat the above procedure anytime you wish to change which relay the transmitter is to
operate.
