441-HH-1
2
Dimensions
– 4.25” L x 2.68” W x .91” D
(note: belt clip adds .43” to depth)
INTRODUCTION
The Air-Eagle XLT TX is a handheld R.F. transmitter capable of sending a single digital command to an
Air-Eagle XLT Receiver located up to 2500 feet away. Any number of transmitters and receivers can be
combined to create a medium-range radio frequency system that operates hazardous or hard-to-reach
equipment from safe, convenient locations. Eight user-programmable frequencies allow multiple systems
to operate simultaneously in the same area without interference. This transmitter will automatically go
into “sleep” mode when not in use to dramatically extend battery life.
INITIAL OPERATION SET-UP
This transmitter comes ready to operate, with batteries installed, and factory programmed to Frequency
#1. No setup is necessary unless you wish to change the frequency or any of the other user
programmable options. See FREQUENCY PROGRAMMING, RELAY PROGRAMMING, AND
TRANSMITTING MODE SETUP.
CONTROLS & INDICATORS
TX LED
Illuminates
RED
when transmitting in standard mode or
GREEN
in
repeater mode. When this LED blinks
RED
during or following a
transmission, the battery needs to be replaced. See note*
Note #1
– The low battery notification signals have been improved to provide more noticeable
indications and to safely disable communications BEFORE a low battery condition can corrupt internal
memory causing device failure. When a low battery is first detected, the TX LED will blink several times
after all buttons are released. If it is possible to replace the batteries now, please do so. If not, the
operator has approximately 15 more button activations. During this time, when a button is depressed
and held, the TX LED will blink SLOWLY. The slow blinking will continue several more times after all
buttons are released. Transmissions are still being sent to the receiver during this time. When a button
is depressed and the TX LED is RAPIDLY blinking, the RF output is disabled and NO signal will reach
the receiver. The batteries MUST NOW BE REPLACED to resume normal functions.
Pushbutton
Transmits an individual RF code to the receiver
