BVM PNP L-39 Albatross, Operating Manual, Page: 30 / 34

BVM®2016 29 09/14/2016
Connecting RX wires
The wires are labeled from the factory. If you are using the DX18, the program is available on
a SD card from BVM. Follow the chart below to connect the servos.
DX18 Connection Chart
RX Port Throttle Aileron Elevator Rudder Gear Aux1
Surface Throttle Right Ail (Ail 2) Elevator Rudder -------- Left Ail (Ail 1)
RX Port Aux2 Aux3 Aux4 Aux5 Aux6 Aux7
Surface Right Flap
(Flap 2) Left Flap
(Flap 2) Brakes Gyro
(Optional)
Steering Speed Brake
X+1 X+2 X+3 X+4 X+5 X+6 X+7 X+8
-------- -------- LED Smoke
Gear -------- -------- --------
DX18 and DX18QQ Transmitter File
The BVM Demo models are setup on Spektrum DX18 transmitters. The file included on the
SD card has all the mixes, rates, expos, and settings done for you. Setting the sub trim and
travel adjustment must be accomplished by the modeler for the specific aircraft. Each aircraft
is tested at the factory using a similar program.
Important!!! Check the directions of all flight controls before each flight.
Switch/Lever/Trimmer Channel Output
Switch A X+5/Channel 15/Gear Landing Gear, Down is Down
Switch B X+3/Channel 13/Aux 6 Lights, Down is off, Up is on
Switch C Elevator Rates Up (0) is High
Switch D Flaps (0) Up is Normal flight
(1)Mid is Flaps Take-Off
(2)Down is Landing Flaps
L. Trim Steering Trim/Aux 6 Down for Right Steering Trim
Up for Left Steering Trim
Switch F Aileron Rates Up (0) is High
Switch G Rudder Rates Down/Away (0) is High
Switch H X+4/Smoke Down (0) Smoke off
Up (1) Smoke on
Right Lever Aux 4/Brakes Up/Away – Brakes off
Mid—Brakes Pulse (Refer To “Pneumatic
Pressure)
Down/Pulled – Brakes on