Buyers Snowdogg EX75II, Installation Manual

Page: 3 / 16

3 3036332_A
11
10
6
7
1
8
9
HDII/EXII Moldboard/Lift Frame Assembly
ITEM QTY. PART NO. DESCRIPTION
1 1 16011002 HDII/EXII LIFT FRAME ASSEMBLY
2 1 16111634 Upper Lift Frame
3 1 16160700 Light Kit
3A 1 16160710 LIGHT, DS
3B 1 16160720 Light, DS
4 1 16101106 Lift Frame Hardware Kit
4A 4 – Carriage Bolt, 1/2-13x1.50
4B 4 – Washer, 1/2"
4C 4 – Nut, 1/2-13 Center Lock
5 1 16101108 Shock Mount Kit, Light (x4)
6 1 16122100 BLADE GUIDE KIT (X2)
7 1 16101100 Trip Pin Kit (x2)
8 1 16101210 Trip Spring Mount Kit (x4)
9 2 16101200 Trip Spring
10 1 16101500 Shock Kit
11
1 16020522 HD75II Moldboard w/Deflector
1 16020532 HD80II Moldboard w/Deflector
1 16020610 EX75II Moldboard w/Deflector
1 16020620 EX80II Moldboard w/Deflector
1 16020630 EX85II Moldboard w/Deflector
1 16020640 EX90II Moldboard w/Deflector
Bill of Materials
The moldboard can be propped on 4x4 or the edge of
a shipping pallet to get into position for mounting onto
the a-frame. The moldboard should be lifted and held
in place until secured with a crane using the points
shown. The lift frame can be slid forward on the ship-
ping pallet to mate with the moldboard (Fig. 2).
4.0
3.5
LIFT POINTS
Fig. 2
Fig. 1
1. Attach the Moldboard to the Sector using the Trip
Pin Kit (7) on both the Driver and Passenger Sides.
Do NOT detach the crane as the moldboard is still not
secured.
2. Install the Trip Springs (9) and Trip Spring Hardware
(8) as shown. Tension the trip springs until there is
approximately a .030” gap. It is important that all
springs be at the same level of tension.
3. Install the snow deflector by loosening the fasten-
ers on the top strip of the moldboard. The deflector
fits between the black retainer strip and the stainless
moldboard. Only the OUTER TWO fasteners need to
be completely removed.
4. Install the blade guides (6) as shown.
5. The shoes as installed have been adjusted for ship-
ping and may need to be repositioned after the plow
is mounted to a vehicle.