BÜTTNER ELEKTRONIK – Batterie-Control-Booster MT BCB 30/30, MT BCB 40/40, MT BCB 60/40
EN
33
BCB 30/30
BCB 40/40
BCB 60/40
Charging output “BORD” battery:
Lead-acid-, Gel-, AGM-battery – nominal voltage:
12 V
12 V
12 V
Battery capacity (adjustable) recommended:
75 – 300 Ah
100 – 400 Ah
150 – 560 Ah
Pre-set charging programs for Pb-batteries:
4
4
4
Pre-charge current (battery deep discharged < 8 V) max.: 15 A
20 A
20 A – 30 A
Minimum battery voltage to start charging:
0 V
0 V
0 V
Protection-charge voltage at battery over-temperature: 12,80 V
12,80 V
12,80 V
LiFePO
4
-battery – nominal voltage:
12.0 – 13.3 V
12.0 – 13.3 V
12.0 – 13.3 V
Battery capacity (adjustable) recommended:
60 – 300 Ah
80 – 400 Ah
100 – 560 Ah
Pre-set charging programs for LiFePO
4-
batteries:
4
4
4
Protection charge voltage at battery under-/
over-temperature:
12.80 V
12.80 V
12.80 V
“BMS”- control input from BMS, high/low
selectable, Ri=30 kOhm:
yes
yes
yes
Charging input/-output starter battery “START”:
Starter battery nominal voltage:
12 V
12 V
12 V
Battery capacity minimum recommendation:
60 Ah
80 Ah
100 Ah
Mains operation:
Nominal operating voltage (AC):
230 V / 45 – 65 Hz
Voltage range (AC):
190 V – 265 V (full charge power), short time (5 s) 300 V
90 V – 265 V / 45 – 65 Hz
Operating voltage range (AC):
Charging power 110 V (AC) approx.:
90 %
70 %
70 %
Sinusoidal current consumption, power factor
correction (CosPhi = 1):
yes
yes
yes
Max. power consumption (AC):
520 W
700 W
700 W
Max. current consumption 207 V AC:
2.5 A
3.4 A
3.4 A
current consumption “AC Power Limit” 207 V AC:
2.0 A
2.0 A
2.0 A
“BORD Charge-/buffer-/load current, regulated”
IU1oU2oU3, Pb, LiFePO
4
:
0 A – 30 A
0 A – 40 A
0 A – 40 A
Retention charge current for “START”, regulated:
0 A – 4 A
0 A – 5 A
0 A – 10 A
Automatic lead acid battery-regeneration
Twice a week 1 h:
yes
yes
yes
Fan noise reduction, night mode:
yes
yes
yes
Signal output “Ntz”, indication light / max.:
12 V / 1 A
12 V / 1 A
12 V / 1 A
Power supply function “BORD” (e.g. to supply
at battery replacement):
yes
yes
yes
Technical Data
BCB 30/30
BCB 40/40
BCB 60/40
Booster operation:
Input voltage range “START” (EURO 6 +),
D+ controlled:
10.5 – 16.0 V
10.5 – 16.0 V
10.5 – 16.0 V
Input over-voltage cut-off “START”
(EURO 6 +), max.:
16.5 V
16.5 V
16.5 V
Power consumption on “START”, max.:
470 W
630 W
930 W
Current consumption active on “START”,
DIP switch position “max.”:
0.1 A – 42 A
0.1 A – 57 A
0.1 A – 82 A
Current consumption active on “START”,
DIP switch position “Limit Boo”:
0.1 A – 32 A
0.1 A – 43 A
0.1 A – 65 A
“BORD” Charge-/buffer-/load current, regulated,
IU1oU2oU3, Pb, LiFePO
4
:
0 A – 30 A
0.1 A – 40 A
0.1 A – 60 A
Activation-control input “D+”, for D+,
Terminal 15, ignition:
8 – 16 V
8 – 16 V
8 – 16 V
Signal output “TR”, high load relay/max.:
12 V / 1 A
12 V / 1 A
12 V / 1 A
Pulse operation, training for lead-acid, Gel, -AGM-battery “BORD” while not charging:
Anti-sulphation-peak current pulses, short-time:
up to 100 A
up to 100 A
up to 100 A
Repetition rate:
every 20 s
every 20 s
every 20 s
Under-voltage cut-off:
< 12.0 V
< 12.0 V
< 12.0 V
“T T” input for battery-temperature-sensor “BORD”:
yes
yes
yes
„Sense“-voltage-sense wiring “S-” and “S+”
for battery “BORD”:
yes / yes
yes / yes
yes / yes
Reverse current from battery, stand-by, no mains:
16 mA
16 mA
16 mA
Security-timer per charging phase I-, U1-, U2:
yes
yes
yes
Ripple voltage:
< 30 mV rms
< 30 mV rms
< 30 mV rms
Charging voltage-Limit “BORD” (protection for consumers): 15.00 V
15.00 V
15.00 V
External over-voltage cut-off “BORD” (20 s):
15.20 V
15.20 V
15.20 V
Short-circuit-/reverse charge- security protection:
yes
yes
yes
Device installation orientation:
any
any
any
Temperature range:
–20/+45° C
–20/+45° C
–20/+45° C
Speed and temperature controlled fans:
yes
yes
yes
Cont. reducing charge power at over-temperature:
yes
yes
yes
Security cut-off at over-temperature:
yes
yes
yes
CI-Bus interface (OEM only)
yes
yes
yes
Service interface (restricted service access)
yes
yes
yes
Protection class / type:
I / IP21
I / IP21
I / IP21
Dimensions, incl. mounting flanges (w/h/d, mm):
270 x 300 x 70
270 x 300 x 70
270 x 300 x 70
Weight:
3650 g
3800 g
3950 g
Ambient conditions, air humidity: max. 95 % RF, no condensation
Safety regulations:
EN 60335-2-29
