INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 47 of 62
It enables the weights hidden behind
spokes mode in manual (disabled by
default).
It enables the weights hidden behind
spokes mode in semiautomatic.
After the scanning, the machine places
the wheel for the fitting of the weight
on the outer side, in the point indi-
cated by the chosen program. In case
the “weights behind spokes” button is
pushed, the machine places the wheel
for the fitting of the weight behind the
first spoke (spokes position detected
by the scan) (enabled by default).
It allows you to change the unit of
measure of the distance of the weights
fitting point from mm to inches and
vice versa.
Enable/disable the led light functions
(enabled by default).
Enable/disable the dynamic residues
in the ECO-WEIGHT function (enabled
by default).
Enable/disable the functions of motor-
bike balancing (disabled by default).
Enable/disable the encoder mounted
on the spin motor (enabled by default).
Enable/disable the automatic RUN-
OUT function (inside rim) (disabled
by default).
It allows you to change the unit of
measurement of the rims width from
mm to inches and vice versa.
It allows you to set the size values of
weights (see Par. 15.1.2).
Enable/disable the RUN-OUT functions
(tyre outside) (GAR338) (disabled by
default).
Enable/disable the functions of ma-
chine printing (disabled by default).
It allows you to change the unit of meas-
urement of the rim diameter from mm
to inches and vice versa.
Enable/disable the weights position-
ing laser pointer function (disabled by
default).
Enable/disable the repositioning of the
wheel at the end of the spin (enabled
by default).
Enable/disable the users function
(disabled by default).
Enable/disable the function of weights
positioning laser wheel inner/outer side
at 12 hours (disabled by default).
1297-M021-1_B
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC