GB
Page 32 of 62
INSTRUCTION, USE AND
MAINTENANCE MANUAL
14.5.1 Balancing mode
The machine allows to perform the balancing (adhesive
weights fitting) by means of the laser pointer.
ON DELIVERY, THE MACHINE IS
CONFIGURED WITH THE CORRE-
SPONDING OPTION SELECTED.
At the end of the spin, on the rim is displayed a laser
pointer indicating the exact point where the adhesive
weight has to be applied.
THE ADHESIVE WEIGHT HAS TO
BE APPLIED FROM THE POINT
HIGHLIGHTED BY THE POINTER
TOWARDS THE INSIDE OF THE
RIM, AND ITS CENTRE LINE MUST
BE RIGHT BY THE SAME POINTER
(SEE FIG. 41).
Fig. 41
In case the operator thinks that the point marked by
the laser is not correct, you can modify it by proceed-
ing as described hereafter:
- from the weight fitting point wheel outer side page
(
Fig. 42
)
2
1
Fig. 42
press the “programs and measurements acquisition”
button (
Fig. 42 ref. 1
). The following screen page
is displayed:
2
1
KEY
1 – Decrease of the weight positioning distance
from the machine
2 – Increase of the weight positioning distance from
the machine
3 – Distance of the point where fitting the adhesive
weight on the outside of the wheel (modifiable
field coloured in blue)
4 – Rim diameter of the point where fitting the
adhesive weight on the outside of the wheel
(modifiable field coloured in blue)
THE PUSH-BUTTONS (1-
2 ) A R E E N A B L E D O N LY
FOR THE FITTING OF THE
A D H E S I V E W E I G H T S .
NOT ENABLED IN CASE OF
CLIP WEIGHTS.
3
4
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
1297-M021-1_B
