INSTRUCTION, USE AND
MAINTENANCE MANUAL
GB
Page 17 of 62
10.0 ELECTRICAL CONNECTION
EVEN THE TINIEST PROCEDURE
OF AN ELECTRICAL NATURE
MUST BE CARRIED OUT BY PRO-
FESSIONALLY QUALIFIED STAFF.
BEFORE CONNECTING THE MA-
CHINE MAKE SURE THAT:
• THE MAIN POWER RATING COR
-
RESPONDS TO THE MACHINE
RATING AS SHOWN ON THE
MACHINE PLATE;
• ALL MAIN POWER COMPO
-
NENTS ARE IN GOOD CONDI-
TION;
• THE ELECTRICAL SYSTEM
IS PROPERLY GROUNDED
(GROUND WIRE MUST BE THE
SAME CROSS-SECTION AREA
AS THE LARGEST POWER SUP-
PLY CABLES OR GREATER);
• MAKE SURE THAT THE ELEC
-
TRICAL SYSTEM FEATURES A
CUTOUT WITH DIFFERENTIAL
PROTECTION SET AT 30 mA.
Connect the machine up to the mains by means of the
3-pole plug provided (230V single-phase).
If the plug provided is not suitable for the wall socket,
fit a plug that complies with local and applicable regu-
lations. This operation must be performed by expert
and professional personnel.
FIT A TYPE-APPROVED (AS RE-
PORTED BEFORE) PLUG TO THE
MACHINE CABLE (THE GROUND
WIRE IS YELLOW/GREEN AND
MUST NEVER BE CONNECTED TO
THE PHASE LEADS). MAKE SURE
THAT THE ELECTRICAL SYSTEM
IS COMPATIBLE WITH THE RATED
POWER ABSORPTION SPECIFIED
IN THIS MANUAL AND APT TO
ENSURE THAT VOLTAGE DROP
UNDER FULL LOAD WILL NOT
EXCEED 4% OF RATED VOLTAGE
(10% UPON START-UP).
1297-M021-1_B
LIBRAK380.3DTEC - LIBRAK380P.3DTEC - LIBRAK430.3DTEC - LIBRAK430P.3DTEC
9.3.5 Monitor fitting (LIBRAK430.3DTEC -
LIBRAK430P.3DTEC)
1. Fit the monitor support plate (
Fig. 16 ref. 1
) to
the monitor support (
Fig. 16 ref. 2
) using the
washers (
Fig. 16 ref. 3
) and the issued screws
(
Fig. 16 ref. 4
).
Fit the monitor (
Fig. 16 ref. 5
) to the plate (
Fig. 16
ref. 1
) with the washers (
Fig. 16 ref. 6
) and the
screws (
Fig. 16 ref. 7
) supplied.
Mount the guard (
Fig. 16 ref. 8
) to the monitor
support plate (
Fig. 16 ref. 1
) with the washers
(
Fig. 16 ref. 9
) and the screws (
Fig. 16 ref. 10
)
supplied.
2
1
3
3
4
5
6
7
8
9
9
10
10
Fig. 16