SPLITTER
12
PIVOT BRACKET
Align the holes in the pivot bracket with the
holes on the beam and insert and tighten
bolts, spring washers, and flat washers.
The beam can be very heavy and
dangerous i
f
it
tips over and
may cause personal injury.
BEAM TO RESERVOIR
Make sure a helper holds on to the beam
to keep it from falling
.
Reposition the
beam and reservoir so the back of the tank
is facing the vertical beam as shown in
Figure 6a
.
1.
Align the pivot bracket on the beam
assembly to the pivot mount on the tank
weldment and insert the beam pivot pin
and washer. (See
Figure 6b
)
2.
Insert the bridge pin through the hole in
the beam pivot pin.
3.
M10x25
(x4)
Pivot Bracket
Beam
Parallel Lines
32
mm
13
mm
16
mm
19
mm
Figure 5
Figure 6a
Beam Pivot Pin
(x1)
Tank Pivot Mount
Washer
(x1)
Bridge Pin
(x1)
Pivot Bracket
Figure 6b
BEAM LOCK BRACKET
When mounting the lock latch assembly,
make sure the latch rod side of the bracket
is on the same side as the engin
e.
Install
the beam lock bracket to the beam by
using the beam lock M10x25 bolts, spring
washer, and flat washers. (See
Figure 7a
)
1.
M10x25
(x2)
Beam Lock Bracket
Beam
Parallel Lines
32
mm
13
mm
16
mm
19
mm
Figure 7a
M10 X 25
X 4
C
M10 X 25
X 2
E
20 X 110
X 1
D
Bridge Pin
X 1
