Bushnell TROPHY 119598, Instruction Manual

Page: 20 / 320

20
(Step 1)
-set Field
Scan Mode to “On”
(Step 2) -
select Field
Scan "A" (press OK)
(Step 3) -
set Field
Scan "A" Stop & Start
(Step 4)
(opt)-select Field
Scan "B" (press OK)
(Step 5) (opt)
-set Field
Scan "B" Stop & Start
Steps 4 & 5 are
optional
(only
required if you want to
set up a second block
of Field Scan recording
with different stop and
start times)
(Step 6) -select Field
Scan "Interval"
(Step 7)
-
set Field
Scan Interval timing
Note: the Interval
Setting sets the timing
between each image for
both Field Scan "A" and
"B" recording blocks.
next day, the camera would again record an image or video once every
15 minutes between 6:00 and 8:00 AM, and between 5:30 and 7:00 PM.
No Field Scan recording would occur from 8AM to 5:30PM, or from 7PM
to 6AM. Remember, Field Scan recording is independent of normal
triggers due to animal activity–even if no animals enter the IR sensor
coverage zone, an image or video will still be captured every 15 minutes
during the block(s) of time. If an animal triggers the camera “in between”
the 15 minute intervals, it will be recorded.
Note: Field Scan settings of frequent intervals and/or long periods
between start and stop time can reduce battery life.