Fig. 1
Charging In
from AC
>25% >50% >75% >90% FULL
Blinking
<25% >25% >50% >75% FULL
Fig. 3
Checking
Charge Level
Blinking
<25% <50% <75% <90% FULL
Fig. 2
Charging Out
to Device
Slowly Blinking
UNDERSTANDING THE POWERSYNC POWER GAUGE
The 4 LED charge indicators behind the Power Gauge (C) allow you to monitor
the status of the BatteryCharger’s internal battery. While the battery is
charging from the AC wall charger, the LEDs will light up in sequence to show
the charge level as shown in Fig. 1. The LED indicating the current battery
level will blink rapidly while charging. When charging is complete, all LEDs
remain on for 10 min., then shut off until the Power button is pressed.
While the BatteryCharger is charging your connected device (Power button
must be pressed), the LEDs will monitor the BatteryCharger’s battery level as
shown in Fig. 2, with a single LED blinking once every 15 sec. (shows active
charging but conserves battery power).
You can also check the current level of the BatteryCharger’s battery charge
anytime by pressing the Power button, even when it is not connected to the
charger or an external device. The LEDs will glow steadily to indicate the
charge level % as shown in Fig.3. , then shut off after 10 seconds.
The Field Light will glow during charging. You can also press
the power button at any time to turn it on to help insert the
USB cable into the Output port when you’re charging at night.
Field Light
4
