DEFROSTING
Defrosting needs to be carried out when the ice layer reaches a thickness of 5mm.
Set the thermostat to 0 and move your food and beverages to another cool place. Do not use any objects to
remove the ice or frost, it must be allowed to melt naturally. Once the ice has melted, dry the inside of the
fridge and freezer compartment.
REVERSING THE FRONT DOOR HINGES
The door hinges from the right side. To change the hinge side, simple unscrew the door hinges from the
fridge cabinet, move to the other side and re-affix using the same screws. Detailed instructions as follows:
•
Carefully remove the top, middle and bottom hinges and both doors.
•
Affix bottom hinge to the preferred side of fridge cabinet. Only tighten screws finger tight.
•
Move the bottom hinge pin to the other side of the hinge.
•
Locate main door onto the bottom hinge.
•
Affix middle hinge to fridge cabinet. Only tighten screws finger tight.
•
Locate freezer door onto the middle hinge.
•
Affix top hinge to fridge cabinet. Only tighten screws finger tight.
•
Align the freezer door until it is square with the fridge cabinet.
•
Tighten top hinge screws fully.
•
Align the main door until it is square with the fridge cabinet.
•
Tighten bottom hinge screws fully.
•
Tighten the middle hinge screws fully.
•
With the doors closed, carefully apply moderate heat with a heat gun or hair dryer to the rubber seals
one section at a time. Once warm and softened, the rubber will pull in towards the fridge cabinet and
create a flush seal.
•
If you are unsure at any stage, please call Bushman head office on (03) 9437 0737 for assistance.
TECHNICAL SPECIFICATIONS
DC190-L
DC285-L
COMPRESSOR
Secop BD50
Secop BD50
VOLTAGE
12 V / 24 V
DC
12 V / 24 V DC
REFRIGERANT
170g R134a
190g R134a
EXTERNAL
DIMENSIONS
(mm)
W 600
D 600
H 1380
W 600
D 700
H 1550
NETT WEIGHT
50 kg
62 kg