INSTALLATION IN A CAVITY WITH THE MOUNTING KIT
DC-L fridges are designed to be installed in a cavity. We recommend allowing a minimum 5mm gap in width
and height for ease of installation. A minimum gap of 50mm is recommended for the rear. Refer to the
following table for the recommended cut-out dimensions.
MODEL
CUT-OUT CAVITY DIMENSIONS (MM)
WIDTH
DEPTH
HEIGHT
DC190-L
605
575
1385
DC285-L
605
675
1555
VENTILATION
Two vents need to be provided from the rear of the fridge cavity to the outside environment, or to the general
area where the fridge is located. The vents should be located at the bottom and top of the fridge cavity and
have a free cross section of at least 300cm2 each. This allows for natural thermal air flows across the
condenser. As a general rule, the more ventilation you can provide, the better.
MOUNTING KIT
The mounting kit is first affixed to the side and top of the fridge cabinet using the screws provided.
Once the fridge has been connected to the power supply and moved into its final position, the mounting kit
can be affixed to the front of the cavity.
OPERATING THE FRIDGE
THERMOSTAT
•
Turn the thermostat knob around from 0 to power up the fridge.
•
The cooling level can be set between 1 and 7.
•
7 is the coldest setting and 1 is the warmest.
EQUALISING THE FRIDGE
During the first 24 hours of operation, your compressor will operate for longer than usual. This process allows
the internal air temperature, food, drinks, condenser and insulation to equalise.
ENERGY SAVING TIPS
•
Have a much ventilation as possible – the more the better.
•
Keep the fridge out of direct sunlight whenever possible
•
Only open the fridge or freezer door when necessary
•
Allow hot food to cool down before placing inside the fridge
•
Defrost the fridge as soon as a layer of ice forms
•
Set the fridge to be only as cold as necessary
CLEANING
Wash the inside of your fridge with luke warm water and a mild soap. Never use abrasive or corrosive
cleaning agents, steel wool or scouring sponges. A soft sponge, towel, or soft brush is recommended.
Always keep the inside of the fridge clean and dry. Remove any condensate water or ice which gathers in or
near the tray under the freezer compartment.
Be careful when opening or closing the freezer door if ice has been allowed to accumulate in this area.
Keep the doors of the fridge ajar when the fridge is not in use, to allow fresh air to circulate inside the fridge
compartment.
