Bush FVPZAPPER100, Instruction Manual

Page: 16 / 41

Power Connection
IMPORTANT: This set top box is designed to operate on 12V DC. For this, an adaptor is used which gives 12 V voltage.
Connect this adaptor to a system that supplies 220-240 V AC, 50/60Hz.
After unpacking, allow the set-top box to reach the ambient room temperature before you connect the set to the mains.
Note: If a car cigarette lighter socket power plug adaptor is going to be used, it should be noted that if the output
voltage reduces to lower than 12V, a smartcard error can be caused.
AC Adaptor
To POWER INPUT
DC12V Terminal
Power On-Off
Be sure that you put through all the cable connections. After plugging in the power adaptor cord of the set-top-box
to the mains supply, a LED will be seen on the front panel (Standby mode). When the set-top-box is first powered up
please wait for a while before activating the receiver since booting of software will take some time. Then, you can
turn on your digital set-top box by pressing the standby button on the remote control. You will see that the LED on
the front panel will change (Power on mode).
Auto Power Down:
The Auto Power Down option in Settings>More menu is set to 4 Hours by default. If the box has been left on and
not been operated during the set time, it will switch into standby mode after the set time has expired. A message
will be displayed two minutes before going into standby mode. You can disable this option by setting as Off or set
between 1 to 8 hours.
Antenna Connection
Back side
of the set top box
ANTENNA IN
This illustration shows how to connect an antenna. Use ANTENNA IN to connect to an antenna system.
Connections
Bringing it all together
Connections 15
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105.