Bush DHG60GNSS, Instruction Manual

Page: 17 / 37

Installing your gas hob
Bringing it all together
Installing your Electrical Cooker
17
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 257 7271.
Electrical connection of your hob
Before proceeding with the electrical connection, verify
that the current carrying capacity of the system and the
socket is adequate for the maximum power rating of
the hob.
- Electrical installation of the residence and the plug
in use must be earthed and conform with safety
regulations.
- If there is no dedicated hob circuit and fused switch,
they must be installed by a qualified electrician before
the hob is connected.
- The fused switch must be easily accessible once the
hob has been installed.
- Do not use adaptors, multiple sockets and/or
extension leads.
HOB
Minimum
42 cm
Minimum
42 cm
M
inimum
65 cm (
with
hood)
M
inimum 70
cm (
without
hood)
The appliance should not be installed directly above a
dishwasher, fridge, freezer, washing machine or clothes
dryer.
If the base of the appliance is accessible by hand, a barrier
made from a suitable material must be fitted below the
base of the appliance, ensuring
that there is no access to
the base of the appliance .
The appliance can be placed close to other furniture on
condition that, in the area where the
appliance is set up,
the furniture’s height does not exceed the height of the
cooktop.
Installation of the Hob
The appliance is supplied with an installation kit including
adhesive sealing material, fixing brackets and screws.
Cut the aperture dimensions as indicated in the figure.
Locate the aperture on the worktop so that, after the
hob is installed, the following requirements are followed:
W (mm) 580 min. A (mm) 50
D (mm) 510 min. B (mm) 100
H (mm) 40 E (mm) 10
C1 (mm) 560 min. F (mm) 10
C2 (mm) 480/490
W
D
C2
A
B
C1
H
F
HOB
W
D
C2
A
B
H
Separator
E
E
H
Separator F
HOB
- Place the hob in the cut out. Mark the location of the
hob on the cooktop.
Worktop
Hob
Marker
- Remove the hob. Place the gasket on the line you marked.
Make sure that the line centres the gasket. Ensure that the
junctions overlap at the corners and no gap is left along
the sealing material.