Bush DHG60GNSS, Instruction Manual

Page: 19 / 37

Installing your gas hob
Bringing it all together
Installing your Electrical Cooker
19
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 257 7271.
to the gas supply in the country for which it has been
produced. The main country of destination is marked
on the rear cover of the appliance. If you need to use it
in another country, any of the connections in the figure
below may be required. In such a case, contact local
authorities to learn the correct gas connection.
Gas pipe
Gas pipe
Gas pipe
Seal
Seal
Seal
Hose fitting
Hose
fitting
Hose
fitting
Hose fitting
Gas hose with collar
Gas hose
with collar
Mechanical
gas hose
Mechanical
gas hose
Gas pipe
Seal
Hose
fitting
Hose
fitting
Gas pipe
Hose
fitting
Mechanical
gas hose
Changing the gas inlet
For some countries, the gas inlet type can be different for
NG/LPG gases. In this case, remove the current connection
components and nuts (if any) and connect the new gas
supply accordingly. In all conditions, all components used
in gas connections should be approved by local and/or
international authorities. In all gas connections, refer to
the “Assembly of gas supply and leakage check” clause
explained above.
Electrical Connection and Safety (If available)
WARNING-
The electrical connection of this appliance
should be carried out by an authorised service person or
qualified electrician, according to the instructions in this
guide and in compliance with the current local regulations.
WARNING- THE APPLIANCE MUST BE EARTHED.
- Before connecting the appliance to the power supply, the
voltage rating of the appliance (stamped on the appliance
identification plate) must be checked for correspondence
to the available mains supply voltage, and the mains electric
wiring should be capable of handling the appliance’s
power rating (also indicated on the identification plate).
- During installation, please ensure that isolated cables
are used. An incorrect connection could damage your
appliance. If the mains cable is damaged and needs to
be replaced this should be done by a qualified personnel.
- Do not use adaptors, multiple sockets and/or extension leads.
- The supply cord should be kept away from hot parts
of the appliance and must not be bent or compressed.
Otherwise the cord may be damaged, causing a short circuit.
- If the appliance is not connected to the mains with a plug,
a all-pole disconnector switch (with at least 3 mm contact
spacing) must be used in order to meet the safety regulations.
- The fused switch must be easily accessible once the
appliance has been installed.
- Ensure all connections are adequately tightened.
- Fix the supply cable in the cable clamp and then close
the cover.
- The terminal box connection is placed on the terminal
box.
Brown
Green Blue