producTion of inflaTable boaT
6/
32
owner’s manual
assembly and disassembly
7/
32
General
WARNING:
Do not exceed the maximum recommended number
of persons.
Regardless of the number of persons aboard, the total
weight of persons and equipment must never exceed the maximum
recommended load. Always use the seats/seating spaces provided.
Payload.
WARNING:
When loading the craft never exceed the maximum
recommended load.
Always load the craft carefully and distrib-
ute loads appropriately to maintain design trim (approximate level).
Avoid placing heavy weight high up.
Outboard engine.
DANGER:
The maximum motor power of this boat is given in the
specification in this manual. Overpowering a boat can result in se
-
rious injury, death or boat damage. The installation and operation
instructions of the outboard motor can be found in this manual.
DANGER:
You might lose control of the boat when using the motor
at full speed. Accidents may occur. BUSH can not be held respon-
sible for these actions.
3. assembly and disassembly
3.1 The valves
The BUSH valves are especially designed for safe and comfortable use. The
valves are designed flat to increase the comfort in the boat and to prevent
damage the boat.
Operation of the valve:
Take off outside cap
•
(b)
. The valve is closed when the middle screw
(a)
is in upside position.
To open the valve put your finger
•
(a)
in the middle of the valve and push
the middle screw down, turn your finger ¼ until the screw locks.
To close the valve push the screw and turn your finger ¼ until the screw
•
comes up
Pump connection:
Put end piece (the nozzle fitting) of the pump on the valve.
•
Turn right (clockwise) and start pumping.
•
Keep pumping until no air can be put into the boat.
•
When ready, be sure to take off the pump.
•
Be sure to put on the protection cap again (for protection from dirt and
•
damage).
