Using your combined gas cooker
Getting the most from your appliance
Using your Combined Gas Cooker
34
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions,
Use of Gas Burners
Ignition of the burners
To determine which knob controls which burner,
check the position symbol above the knob.
Manual Ignition of the Gas Burners
If your appliance is not equipped with any ignition
aid or in case there is a failure in the electric network,
follow the procedures listed below:
For Hob Burners: To ignite one of the burners, press
and turn its knob counter-clockwise so that the knob
is in maximum position, approach a match, taper or
another manual aid to its upper circumference. Move
the ignition source away as soon as you see a stable
flame.
Electrical Ignition by Spark Button
Press the valve of the burner you want to operate and
turn the valve in the counter-clockwise direction so
that the knob is in maximum position and with your
other hand, press the ignition button (
Fig 22
) at the
same time.
Note
: Press the ignition button immediately, because
if you wait, a build up of gas may cause the flame to
spread. Continue pressing the ignition button until you
see a stable flame on the burner.
Fig 22.
Flame safety device:
Hob Burners
Hobs equipped with a flame failure device provide
security in case of accidentally extinguished flames. If
such a case occurs, the device will block the burners
gas lines and will avoid any accumulation of unburned
gas. Wait 90 seconds before reigniting an extinguished
gas burner.
This is an obligation for countries that follow
EU Directives. If your country doesn’t follow EU
Directives,your product may not be equipped with
flame safety device.
Fig 23.
Control of the hob burners
The knob has 3 positions: Off (0), maximum (big flame
symbol) and minimum (small flame symbol). After
you ignite the burner in maximum position you can
adjust the flame length between maximum and min.
positions. Do not operate the burners when the knob
position is between maximum and off positions.
Fig 24.
After the ignition, check the flames visually. If you see
a yellow tip, lifted or unstable flames turn the gas flow
off, and check the assembly of burner caps and crowns
(
Fig 24
). Also, make sure that no liquid has flown
into the burner cups. If the burner flame goes out
accidentally, turn the burner off, ventilate the kitchen
with fresh air, and do not attempt re-ignition for 90 sec.
When turning the hob off, turn the knob in the
clockwise direction so that the knob shows “0” position
or the marker on the knob points upwards.
Your hob has burners of different diameters. The most
economic way of using gas is to choose the correct
size gas burners for your cooking pan size and to bring
Summary of Contents for BSC90DFB
