Using Your Gas Hob
To ignite one of the burners, approach a match,
taper or another manual aid to its upper
circumference and push the corresponding
control knob and turn it counter clock-wise.
Medium regulation of the flame will be obtained
by turning the control knob between maximum
position (big flame) and the minimum position
(small flame).
Ignition by Spark Button:
Press the valve of the burner you want to operate
and turn the valve in the counterclockwise
direction (clockwise for the grill burner); and with
your other hand, press the ignition button at the
same time. Press the ignition button immediately,
because if you wait, a build up of gas may cause
the flame to spread. Continue pressing the
ignition button until you see a stable flame on the
burner.
FFD (Flame Failure Device) models will shut off the
gas to any burner which is accidentally
extinguished by spillage or wind. The gas will shut
off within 45-60 seconds and re-ignition should
not be attempted for 60 sec.
The installation of the gas appliance to natural
gas or LPG must be carried out by a <GAS
SAFE> registered engineer. Engineers shall take
due account of the provisions of the relevant
British Standards Code of practice, the gas safety
regulations and the building standards (Scotland)
(Consolidation) regulations issued by the Scottish
development department.
The gas burners adapt to different types of gas,
by replacing the corresponding injectors to gas
on use.
There fore it is necassery to;
- Cut off the feeding gas flow and electric
current.
- Remove the loose burner parts.
- Unscrew the injectors.
- Replace the injector with the ones
corresponding to the type of gas that is going
to be used, according to the information on the
transformation chart.
GAS CONVERSION
Changing the gas connection
8
Injectors replacement
This appliance is manufactured so that it is
capable of conversion to LPG.
Select the injectors to be replaced according to
the "Table for the choice of the injectors". To
replace the injectors: Remove pan-supports and
burner parts from the hob top. Using a spanner,
remove the injector from its housing and replace
it by the proper one according to the kind of gas
(see the “ Injector Table").
Adjusting The Simmer Flame Position for Simmer
flame position, the by pass screw must be
loosened if converting from LPG to NG, the same
screw must be tightened.
- Make sure that the appliance is unplugged from
the electric supply and the gas feed is open.
- Ignite the burners and leave them on in minimum
position.
- Remove the knobs and rubber seals because
the screws are accessible only when the knobs
and the seals are removed.
- This procedure must be repeated for each of the
valves.
- With the help of a small screw driver tighten or
loosen the by pass screw by 90°, which mak
o
o
es
the flame of the burner reduce to the minimum.
When the flame has a length of at least 4 mm,
the gas is well distributed. Make sure that the
flame does not die out when passing from the
maximum position to the minimum position.
After the adjustment is complete replace the
rubber seal and replace the knob.
Rapid / Wok Burner: 22-26cm
Semi-rapid Burner: 14-22cm
Auxiliary Burner: 12-18cm
CORRECT
INCORRECT
circular saucepan base
INCORRECT
saucepan’s base had not settled
INCORRECT
small saucepan diameter
Customer Helpline
0345 257 7271
User Instructions
