Gas Connection
- When connecting any hoses or fittings to the
appliance, the appliance inlet pipe must be
gripped firmly to prevent any internal damage from
twisting.
The gas supply pipe to the appliance should be
protected from damage and should not come into
contact with any parts which may become hot.
- The gas feeding manifold protruding from the
back of the cooker completely visible. Anything
that is connected to this manifold (hose, nut etc.)
must be connected carefully to ensure that it will
not heat up during operation.
- It is highly recommended to block the access
to pipe connection, while the cooker is in use or
when the gas supply is open.
- During the gas connection process, the pipe of
the appliance should be kept stationary, while the
connected part (mechanical, LPG or NG nut) is
fixed. Always use the seals supplied in the spare
set between the connection surfaces.
-
Remember that this appliance is ready to be
connected to a gas supply in the country for
which it has been produced. The main country of
destination is marked on the rear cover of the
appliance. If you need to use it in another country,
any of the connections shown in the diagram at
the bottom left of this page may be required. In
such a case, contact the local authorities to learn
the correct gas connection.
In all cases, the flexible gas hose should neither
pass behind an oven, nor be in contact with
premises that may cause combustion.
Furthermore, make sure that all connections are
according to the national legal
requirements for gas appliances.
IMPORTANT
- The appliance should be installed or converted
to LPG by a QUALIFIED INSTALLATION
ENGINEER.
- Failure to comply with this condition will render
the guarantee invalid.
- The appliance must be installed by a <Gas
Safe> Registered engineer.
- The appliance must be installed in compliance
with local regulations in force.
- Installation engineers must comply with current
laws in force concerning ventilation and
evacuation of exhaust gases.
- Always unplug the appliance before carrying
out any maintenance or repairs.
- The minimum distance between the appliance
and combustible surfaces must be 20 mm.
- Only use gas hoses and fittings which comply
with all current regulations in force.
carried out
5
510 mm
580 mm
42 mm
Neighbourhood walls A[mm] B[mm]
Combustible
60 150
Non-combustible 40 50
B
A
CAUTION! THIS APPLIANCE MUST ONLY BE INSTALLED BY A <GAS SAFE> REGISTERED ENGINEER.
Locating Your Built-in Hob
- The Hob is supplied with a special seal in
order to avoid any liquid ingress in the work top.
Cut out an opening in the top of your kitchen unit
that corresponds to the measurements given in
the figure at the top of this page. When creating
this cutout, please be aware that the hob must
be:
Seal
Hose
Fitting
Hose
Fitting
Gas Hose
with Collar
Gas Pipe
Seal
Hose
Fitting
Gas Hose
with Collar
Gas Pipe
Mechanical
Gas Hose
Seal
Hose
Fitting
Gas Pipe
Seal
Hose
Fitting
Hose
Fitting
Mechanical
Gas Hose
Gas Pipe
Mechanical
Gas Hose
Hose
Fitting
Gas Pipe
Installation
Customer Helpline
0345 257 7271
