ELECTRICAL CONNECTION
o
o
Before proceeding with the electrical connection
verify that :
- The current carrying capacity of the system and
the socket is adequate for the
maximum power
rating of the hob.
- The voltage indicated on the capacity label is the
same as the supply voltage.
- Do not use any reductions , adapters or shunts
because they may cause overheating.
- Ensure the socket has an earth terminal.
· The mains socket outlet must be situated near the
appliance and kept easily accessible at all times
during operation.
6
ELECTRICAL CONNECTION (UK ONLY)
Appliance must be connected to a 240 Volts 50
Hz AC supply by means of a three pin socket,
suitably earthed and should be protected by a 3
amp fuse in plug.
The appliance is supplied with a 13-amp 3-pin
mains plug fitted with a fuse rated at 3 amp and
approved to BS1362.
The plug contains a removable fuse cover that
must be refitted when the fuse is replaced. In the
event of the fuse cover being lost or damaged, the
plug must not be used until a replacement cover
has been obtained. If the mains plug is unsuitable
for the socket outlet in your home or is removed
for any other reason, then the fuse should be
removed and the cut off plug disposed of safely to
prevent the hazard of electric shock.
There is a danger of electric shock if the cut off
plug is inserted into any 13 amp socket outlet.
IMPORTANT
How to wire a 13 amp plug
Follow reconnection diagrams strictly. The
protective earth connection (PE) must be
connected to the Terminal marked ( ). During
installation, please ensure that insulated, heat
resistant cables are used.
- 100mm from the edge of the cooker to any
combustible materials.
- 700mm underneath any overhead cupboards
or shelving
- 750mm underneath any overhead extractor
fans. Apply the self adhesive seal to all edges of
the cutout and carefully fit the hob into the
opening in such a way that the knobs will be
right side.
- The leaf springs located on the lower left and
right sides of the hob will fix the hob in the
opening.
- This appliance must be installed according to
the manufacturers installation instructions, local
building regulations, gas authority codes and
electrical wiring instructions.
The appliance is provided with a supply cord and a
plug. Replacement of the mains cable must be
carried out by a <GAS SAFE> qualified engineer.
L
N
B
L
U
E
GREEN
B
R
O
W
N
Installation
Customer Helpline
0345 257 7271
