U
S
A
G
E
Mode Descriptions
Stand-By-Mode
S-Mode
The mains are applied to the hob control
and all heater displays are off or a residual
heat display is active.
Operating-Mode
B-Mode
At least one heater display shows a heat
setting between ´0` and ´9`
Lock Mode
VR-Mode
The hob control is locked.
Turn On and Turn Off The Appliance
Select Heater
- If the appliance is in Stand-By-Mode, it is put in
Operating-Mode by pressing the On/Off button
at least 1 second. A buzzer signal
indicates the successful operation acoustically.
On all heaters a ´0` appears and
- If there is no operation within 10 sec, the
display of all heaters will turn off.
- If the displays are turned off, the heater will be
set into Stand-By-Mode.
- If is pressed for more than 2 sec (in
Operating-Mode), the appliance is switched off
and is set into the S-Mode again. The appliance
can be turned off by pressing at any time;
even if other buttons are pressed simultaneously.
If there is any residual heat
this will be indicated in the
- If a single heater is chosen with the
corresponding Active/Deactive Heater Button
, the Decimal Point of the related Heater Display
flashes. For the selected heater, you can set the
heat level between 1-9 by touching the Heat
Setting Buttons or .
a decimal point
will flash on all heaters (1 sec on, 1 seco off).
remaining in any
heater,
display of the
corresponding heater with the letter 'H'.
Set Cooking Level With and Without Heat Boost
All heaters are equipped with heat boost
functionality.
If the heat boost is active, than the heater will be
operated with maximum power for the period of
the heat boost time, that is dependent from the
selected heat setting. This is indicated through a
flashing ´A`, alternating with the heat setting value
(e.g. 0,5 sec ´A` and 0,5 sec ´9`) in the heater
display. Once the heat boost
If the heat boost should be used for a heater,
heater level 9 must be operated by pressing
starting from level 0. After setting the heat to level
9 , ´A` will be indicated alternating. This means
that level 9 and heat boost is active now.
time has finished,
only the heat setting number will be displayed.
The buttons must be pressed within 3 sec,
otherwise the heater selection is erased and heat
setting dot will disappear (Decimal Point). If there
is no further operation within 10 sec, the heater
falls back into the S-Mode.
The heat setting can always be changed by
pressing or between level 1-9.
Each button operation or each display change is
quitted by a buzzer signal.
The heat boost can be turned off by pressing
until heat setting ´0` appears.
If the heat boost should be used, it can always be
activated by actuating again if the heat setting
is set to level 9. In the heat display, ´A/9` flashes.
A selective heater can be turned off with 3
different ways:
- Simultaneous operation of and buttons
- Reduction of the heat setting to ´0` by operating
button
- Use of
Turn Off Individual Heaters
the timer function, to turn off a heater
+
+
6
Customer Helpline
0345 257 7271
