Electrical connection of your hob
- Before proceeding with the electrical
connection, verify that the current carrying
capacity of the system and the socket is
adequate for the maximum power rating of the
hob.
- Electrical installation of the residence and the
electrical current plug in use must be earthed
and conform with safety regulations.
- If there is no dedicated hob circuit and fused
switch, they must be installed by a qualified
electrician before the hob is connected.
- Fused switch must be easily accessible once
the hob has been installed.
- Do not use adaptors, multiple sockets and/or
extension leads.
- This appliance conforms with the requirements
ofthe following EEC Directives:
1. Vitroceramic hob EEC/73/23 and
93/68, EEC/89/336 relating to radio interference,
2. EEC/89/109 relating to contact with
foods.
- A circuit breaker with a contact opening of at
least 3 mm, rated 25 A and delayed functioning
type must be installed inside the supply circuit.
The electrical connection of this hob should be
carried out by an authorised service or a qualified
electrician, according to the instructions in this
guide and in compliance with the current
regulations.
- Prior to installation, ensure that the local
distribution conditions and the adjustment of the
appliance are compatible.
- The laws, ordinances, directives and standards
in force in the country of use are to be followed
(safety regulations, proper recycling in
accordance with the regulations, etc.)
Locating your built-in hob
After removing the packaging material from the
appliance and its accessories, ensure that the
hob is not damaged. If you suspect any damage,
do not use the appliance and contact an
authorised service personal or a qualified
electrician immediately.
- This built-in hob is to be inserted into a cut out
of a worktop. It will be electrically connected with
the switch box below, especially provided for this
purpose.
- Create an opening with the dimensions shown
in the picture below.
- Apply the one-sided self-adhesive sealing tape
supplied all the way round the lower edge of the
cooking surface along the outer edge of the glass
ceramic panel. Do not stretch it.
- Screw the 4 worktop mounting brackets on
the side walls of product.
worktop mounting bracket
4
Installation
Customer Helpline
0845 600 4632
