Bush 487/6474, Instruction Manual

Page: 26 / 48

26
Using your Outdoor DAB Radio
Let’s get started
Using your Outdoor DAB Radio
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
FM Radio mode
If you are not already in FM mode, press and release the Mode button to go to FM mode
(check the display).
If you were listening to an FM station when you switched the Radio off then this station
will be automatically selected when you switch the Radio back on.
Tuning to an FM station
Press and release the Scan button to scan up the frequency band. Use the Tune control
to fine tune each frequency in 0.05MHz steps.
Note: If reception is still poor try moving the radio to another location.
Changing the Scan setting
In FM mode:
1. Press and hold the Menu/Info button until FM <Scan setting> is displayed. Press and
release the Enter button. The current Scan setting will have an ‘*’ in the top right of the
display.
There are two different options to choose from:
Strong stations: The scan will only stop when a strong signal strength is received which
should also result in a better audio quality. It is possible that the station
you are scanning for may be missed using this option.
All stations: The scan will stop for every station it receives, even if the signal strength
is poor.
2. Use the Tune control to choose from the two options available and press and release
the Enter button to confirm.