C
ordless
-
drill
adjustement
1
2
3
When setting up the FALZ CUTTER we must remove and make
sure that cordless drill accumulator is removed from the
Accumulator drill machine
Only when we are definitely sure that everything is connected properly only then we
place the battery inside the cordless drill machine and start working!
1
2
3
Position the cordless drill machine on the 10mm rotating hex cap head
axle and tighten it.
Tighten the cordless drill inside the Holder with the key that comes
with the the tool. The holder must be tightened until the holder sides
stops against the cordless drill machine.
Adjust and Tighten the stabilization bar. One side must be positioned
right by the Falz Cutter specific side and other side must adjusted right
by the Drill machine angle so the stabilization bar stops by Accumulator
drill machine.
BEFORE INSERTING THE BATTERY IN CORDLESS DRILL MACHINE, READ THE MAN-
UAL
“
i
mportant
safety
information
for
operating
the
f
alz
C
utter
”
