Busch+Müller 168, Instruction Manual

Page: 24 / 88

24
6.3 Suspended assembly
ATTENTION:
If the headlight 1 is to be mounted in a suspended position, please ensure to not simply
turn it or place it upside down. Other road users would be dazzled!
!
In order to align the headlight correctly in a suspended position, loosen the plastic ring around the
headlight 1 and turn it by 180°. For this purpose, detach the headlight 1 rom the Busch + Müller
bracket 2 first and then slightly spread the circumferential plastic ring and move the ring around the
headlight 1 by 180°.
IMPORTANT: Make sure that the cable outlets on the headlight 1 always point straight down. This is
the only way to ensure that the light pattern of the headight 1 is ideally aligned and protected from
water penetration in the best possible way.
NOTICE The headlight 2 must be mounted either upright (Busch + Müller bracket 2 and the cable
outlet pointing in exactly the same direction) or suspended and rotated by 180° (Busch + Müller bracket
2 and the cable outlet pointing in exactly the opposite direction). Otherwise, there is a risk that the
headlight 1 might adjust all by itself.
For suspended assembly, the reflector 3 must not be mounted „overhead“. Please mount the the reflec-
tor 3 elsewhere parallel to the road at a height between 400 and 1,200 mm.