Specifications
Thank you for choosing the products of Armytek Optoelectronics Inc., Canada.
Please read this manual carefully before using the flashlight.
USER MANUAL
FLASHLIGHTS IN THE WORLD
THE MOST TECHNICALLY ADVANCED
Model
Prime A1
Pro
Prime A2
Pro
Prime C1
Pro
Prime C2
Pro
LED
Cree XM-L2
Optics
TIR
Brightness stabilization type
FULL stabilization (constant brightness)**
Light output, OTF lumens*
370
500
400
1
050
Peak beam intensity, candelas
3050
4250
3100
8800
Hotspot/spill
20°/
8
0°
Beam distance
*
120 yards / 110 meters
142 yards / 130 meters
121 yards / 111 meters
206 yards / 188 meters
Hotspot diameter at 330
feet / 100
meters
1
6 meters
Modes and runtimes (measured for
Sanyo Eneloop AA 2000 mAh /
Armytek CR123A 1500 mAh / Armytek
18650 Li-Ion 3100 mAh to the
decrease to 10% of initial brightness)
Firefly1: 0.15lm / 90d
Firefly2: 1.7lm / 200h
Main1: 10 lm / 25h
Main2: 70 lm / 3h
Main3: 210 lm / 1.2h
Max: 370 lm / 30min
Strobe: 10Hz
Warning: 0.6Hz
Firefly1: 0.15lm/130d
Firefly2: 1.7lm / 300h
Main1: 10 lm / 48h
Main2: 70 lm / 9.5h
Main3: 210 lm / 2.5h
Max: 500 lm / 1h
Strobe: 10Hz
Warning: 0.6Hz
Firefly1: 0.15lm/130d
Firefly2: 1.7lm / 300h
Main1: 10 lm / 40h
Main2: 70 lm / 5h
Main3: 210 lm / 2h
Max: 400 lm / 35min
Strobe: 10Hz
Warning: 0.6Hz
Firefly1: 0.2lm / 100d
Firefly2: 2lm / 18d
Firefly3: 15lm / 72h
Main1: 70lm / 18h
Main2: 200lm / 9h
Main3: 420lm / 3.8h
Max: 1050lm / 1.5h
Strobe: 10Hz
Warning: 0.6Hz
Recommended power source
1xAA /
1x14500 Li-Ion
2xAA
1xCR123A /
1xR123 Li-Ion
1x18650 Li-Ion /
2xCR123A/2xR123 Li-Ion
Size
Length
4.14
”/
105
mm,
body diameter 0.96”/
24.5mm
Length
5.95
”/ 1
51
mm,
body diameter 0.96”/
24.5mm
Length 3.
50
”/ 8
9
mm,
body diameter 0.96”/
24.5mm
Length 4.73”/ 120mm,
body diameter 0.96”/
24.5mm
Weight (w
/o
batteries)
2.22oz / 63g
2.26oz / 64g
2.05oz / 58g
2.19oz / 62g
We recommend to use Sanyo Eneloop AA rechargeable batteries instead of ordinary AA batteries to obtain higher brightness
and longer runtimes.
Armytek Optoelectronics Inc.
is a Canadian manufacturer that produces powerful and reliable flashlights designed especially for your
needs applying in them components made in the USA and Japan.
.
10 years no-hassle warranty
§
Superb light of amazing constant brightness due to powerful electronics and active temperature control without timers
§
Efficient TIR-optics and no “tunnel vision” effect even after continuous use
§
Multicolor Warning Indication of low battery level and high temperature
§
Side switch for comfortable one-hand operation and easy modes switching with advanced operation
§
Multicolor State Indication and ultra low current drain in OFF-state - more than 25 years
§
Removable magnet in the tailcap, firm holster, removable clip, strong lanyard and possibility of tail-stand for multipurpose use
§
Compact and light-weight flashlight of guaranteed durability stands up harsh impacts and falling from 10 meters
§
Total protection from water, dirt and dust penetration - flashlight continues to work even at the depth of 10 meters
* Light outputs for flashlights with Warm light are about 7% less, beam distances are about 3% less.
** C2 Pro: in Max mode Full stabilization is for 20 minutes, then it is Step.
Prime
Warnings
C2 Pro only:
With ambient tempe25°C the flashlight delivers light in Maximum mode for about 8-10 minutes and then the
brightness steps down to the Main3 mode. 40-60 seconds afterwards the brightness increases to the Maximum mode again. This
stepping goes cyclically to maintain the user's safety and the flashlight's functionality. In the conditions of good air-cooling the
flashlight delivers constant light even in Maximum mode. It does not use timers, but real active temperature measurements
.
Armytek Optoelectronics Inc. shall not be liable for any harm done to the user if it
was caused by improper use of the product.
1.
Always follow the instructions from this manual and recommendations on battery usage.
2.
Apply only the recommended power sources.
3.
Do not reverse battery polarity.
4.
Do not use different power sources together, i.e. old ones with new ones, charged with
discharged. Do not use different types of batteries combined as the element with less
capacity can be damaged.
5.
Do not modify or recast the flashlight and its components as it will deprive you of the
warranty.
6.
Do not allow water or any other liquid to leak into the flashlight.
7.
Do not aim a turned-on flashlight at people's or animals' eyes – it can cause temporary
blindness.
8.
Do not allow children to use the flashlight without your assistance.
Care and Storage
It is recommended to clean the threads and O-ring
s
off dirt and old grease. Remember that secure protection from water and dust
cannot be provided by worn out sealing. And fouling as well as lack of lubricant cause fast wear-out of threads and sealing rings.
To clean the threads do the following:
1.
Unscrew the tailcap and remove the sealing ring carefully with a toothpick (do not use sharp metal things as they can damage the
ring).
2.
Wipe the sealing ring thoroughly with a soft cloth (or tissue). Do not use solvents. If the sealing ring is worn out or damaged
replace it by a new one.
3.
Clean the metal threads with a brush using ethanol. Be careful not to allow applied liquid to get inside the flashlight or tailcap as it
can cause fails in functionality of the flashlight.
After cleaning lubricate the thread and the sealing ring with polyalphaolefin-based silica grease, e.g. Nyogel 760G.The application of
automotive and other improper grease can cause swelling and damage of the sealing rings.
In case of active operation and exploitation in dusty environments, it is recommended to perform cleaning and lubricating of the parts
as often as required, even if it is more than twice a year.
Service and Warranty
Specifications are subject to change without notice.
Armytek provides free warranty repair for 10 years from the purchase.
Warranty doesn't cover damage caused by:
1.
Improper usage.
2.
Attempts to modify or repair the flashlight by nonqualified specialists.
3.
Longtime application in chlorinated or polluted water, or other liquids (other than water).
4.
High temperatures and chemicals' exposure (including the exposure of liquid from defected batteries).
5.
Usage of low-quality batteries.
Armytek Optoelectronics Inc.
Web: www.armytek.com Email:
Address: 67 Vandervoort Dr, Richmond Hill, Ontario, L4E 0C7, Canada
