2
Carton Contents
Located within top of the packing foam you will find the Front
Fender, Rear Fender, Right and Left Footrest assemblies, Handlebar
Clamps, all hardware and Tool Kit. The Front wheel and charger are
located at the bottom of the packaging.
OPEN THE TOP OF THE SHIPPING BOX and Remove the contents
from the top of the foam inserts. Inspect and confirm that you have
all parts and Hardware. Remove the foam separators that protect
the components from damage during shipping. Remove the Front
wheel and brake rotor. Inspect the contents of the box for scratches
in the paint, dents or kinked Brake lines that may have occurred
during shipping. Because these vehicles are 90 percent assembled
and packed at the factory, there should not be any problems, even if
the box has a few scars or dents.
Allow up to 30 Min for assembly.
Check for all parts and hardware before beginning assembly. Follow
these instructions carefully, Checking all bolts, Nuts and screws for
tightness during the assembly process. DO NOT Squeeze the brake
levers until the brakes have been fully assembled
Set the bike on a stable platform at least 18” off the ground.
Position the front fork so that it hangs off one end of the platform
to facilitate front wheel and brake assembly installation.
Enjoy the process and take your time to ensure all components are
secure.
Checking all bolts, nuts and screws for tightness during the
assembly process.
Front Wheel
Folding Foot
Pegs
Handle Bars
assembly
Front Fender
Rear Fender
& Tool Kit
Battery Charger
Harware parts
