9
Repair and Maintenance
WARNING
:
The brake is capable of
causing the electric
motorbike to skid the tire
throwing an unsuspecting
rider. Practice in an open
area free from obstacles
until you are familiar with
the brake function. Avoid
skidding to a stop as this
can cause you to lose
control or damage the rear
tire.
Turn power switch “OFF” before conducting any
maintenance procedures.
Check the Burromax website for any updates on the
latest repair and maintenance procedures.
Adjusting the Brakes
Tools required:
5mm Hex Key wrench
1
To adjust the tension, thread the brake lever adjuster in or out 1/4
to 1/2 turn until the desired brake adjustment is attained. Most
adjustments are complete at this step. If brake still needs further
adjustment, proceed to step 2.
2
If the brake has too much slack, use a 5mm Hex Key wrench to
loosen the brake anchor cable for additional adjustment.
Testing the Brakes
To use the brake, squeeze the lever to increase the pressure on
the brake. The brake lever is fitted with a cable adjuster to
compensate for cable stretch and/or to fine-tune the lever
movement to brake engagement. If brake is not engaging properly,
follow instructions for adjusting the brakes outlined below.
