Further information
page
2
Service settings
(
0#5130
)
•
Signal test
(
0#51310
) - Displays the current signal strength
expressed in both logarithmic form (dBm) and as a percentage
roughly equivalent to the actual received signal level compared to
the practical minimum, divided by the possible maximum range
multiplied by 100.
•
Show voltage
(
0#51320
) - Displays the voltage level being sup-
plied by the connected power adapter.
•
HR codec control
(
0#51330
) - Controls the use of the HR codec
(half rate coder/decoder) used for speech transfer across the
mobile network. This setting is normally set to ‘Enabled’.
•
PSTN detection control
(
0#51340
) - (‘L’ models only) This setting
allows the unit to test for the presence of a valid PSTN landline
connection before dialling outgoing calls. If the link is not valid,
the call will be automatically placed on the mobile connection.
•
No test
(
0#513420
) - When set, the unit will not test for a valid
loop current, but will take the line off-hook and dial out using
the landline.
•
Test loop
(
0#513430
) - When set, the unit will take the line off-
hook, check for loop current (power supplied by the line) and if
current is present, it will dial the number using the landline.
•
Loop & tone
(
0#513440
) - When set, the unit will first check for
loop current and (if found) then check for a dial tone. If both are
present, then it will dial the number using the landline.
•
Restore factory settings
(
0#5140
•
TAPI voice mode
(
0#5150
) - When this option is selected, a con-
nected computer may dial the number using standard TAPI com-
patible software diallers. When a call is initiated by the computer,
the local phone will ring for ten seconds to allow the user to make
the call. If the phone is not picked up, the call is cancelled. When
the TAPI option is not set, the dialling command protocol via the
USB link is compliant with GSM specifications.
•
Tone region selection
(
0#5160
) - Selects the style of tones that
will be heard via the phone earpiece. On ‘L’ models, this also
determines the tone cadence expected from the network for end
of call detection.
•
Show current setting
(
0#51610
) - Indicates the chosen tones.
•
Set to GB (UK)
(
0#51620
) - Use UK standard tones.
•
Set to IE (Eire)
(
0#51630
) - Use Eire standard tones.
•
Set to NL (Netherlands)
(
0#51640
) - Use Dutch standard tones.
Phone settings
(
0#520
)
•
Own number sending
(
0#5210
) - Determines whether your tel-
ephone number is sent via the network (Calling Line Identity, CLI
or Caller ID) to the person you are calling. The outgoing Caller ID
can also be temporarily suppressed (for one call) by first entering
or can be enabled for a single call by first entering
.
•
Dial delay
(
0#5220
) - Sets the delay to elapse, after entering the
last digit, before starting to dial. The range is 1 second to 1 minute
and the factory setting is 3 seconds. When dialling, the call can
be started immediately by entering
#
at the end of the number.
continued
