25
SETTING THE TIMER
1. Alternatively, you can set a timer for each probe. An alarm will sound once the
set time has elapsed. You can switch off the alarm by pressing any button.
2. You can set the time in hours/minutes or minutes/seconds and have the setting
displayed on the LCD screen.
3. Press PROBE/TIMER on the transmitter to select probe 1, 2, or 3. Hold down the
PROBE/TIMER button to switch to the timer mode. The first two decimal places
on the display flash and you can adjust them using + and -.
4. Hold down the + or - button to speed up the process.
5. Press PROBE/TIMER to move to the next two decimal places and set the desired
time. Confirm your setting by pressing PROBE/TIMER.
6. Press START/STOP/CLEAR to start/stop the timer. Your setting is then displayed
on the transmitter and receiver at the same time after the next synchronisation.
Once the timer runs down, an alarm sounds and both displays flash. You can switch
off the alarm by pressing any button.
CLEANING AND MAINTENANCE
1. Leave the probes to cool down completely before cleaning. They get very hot
during use. Make sure to wear heat-resistant gloves to avoid burns.
2. Clean the probes with hot water and a mild detergent and subsequently dry.
Only use a damp cloth to clean the transmitter and receiver.
3. Do not immerse the probes, transmitter, or receiver in water. This can damage
the devices permanently.
