9.
Light the fire using the method in the instructions and ensure that the pilot lights consistently and
the pilot flame envelopes the thermocouple evenly, it is located at the front on the right-hand side.
The pilot should hold in 6-10 seconds. Turn control to main burner, this should light smoothly
within 10 seconds. Ensure the valve gives adequate turn down and the thermostat bulb reduces
the burner rate to off when heated.
Locate thermostat bulb in a cool place off the appliance and preferably outside of any inglenooks,
to ensure it is sensing room air temperature.
Run the appliance for 10 minutes, ensuring burner flames settle evenly.
The gas manifold pressures are factory pre-set using highly accurate equipment, and must not be
altered.
The catalyst is unlikely to need replacement during the life of the heater. The appliance should be
inspected before use and at least annually by an authorised service person. More frequent cleaning
may be required due to accumulation of lint and dust from carpeting etc.
It is imperative that the control compartments, burners and circulating air passageways of the
appliance be kept clean. Replacement parts are available from your local dealer.
18
Accessories
The range of accessories for this stove includes dummy flue kits, which simulate a real stovepipe
and warming shelves. Consult your dealer or Burley for a full list of optional accessories and follow
the instructions for their use.
Using unapproved accessories could prove hazardous and will invalidate the warranty.
User Instructions
Read the instructions before using this appliance.
This appliance requires installation and annual servicing by a Gas Safe™ registered installer
(formerly CORGI).
Use only in a correctly sized and ventilated area.
Any purpose provided ventilation should be checked regularly to ensure it is free from obstruction.
Once the coals or logs have been positioned in accordance with the installation instructions, they
must not be moved except for servicing.
The surfaces of the appliance become very hot during use.
Before cleaning or maintenance switch fire OFF and allow to
cool.
Do not attempt to touch or wipe clean the fire whilst hot,
doing so could result in severe burns or damage to the
paintwork.
TO LIGHT THE HEATER
There are 2 control knobs on the appliance. The left hand one (coloured red) controls On / Off and
High / Low flame. The right hand one (coloured black) is the comfort level thermostat which turns
the fire to pilot position once the desired temperature is reached. Some people prefer to retain a
flame effect using the left hand knob to control its height whilst keeping the thermostat set on hot.
Others prefer to use the fire purely as a heater in which case they will select a flame height then set
the thermostat to a comfort level. In both cases if the room gets too hot, the thermostat will reduce
the fire to pilot setting.
If during use the pilot is alight but the main burner will not light, check the thermostat position and
if necessary select a warmer setting.
M
H
L
Control Knob
T hermos tat
