50
Adjustmentandstart-up
9.11.6 Displaying the lowest and highest values measured
See chpt. 9.9 to access the Parameters menu.
Warning
risk of injury due to wrong adjustment.
▶
Before setting the parameters for the display, choose the type of probe mounted on the device. Refer to
chpt. 9.11.11.
Display
Param
This is
when the
device is be-
ing parame-
tered............
....................
This is
when the
device is be-
ing parame-
tered............
....................
pH
TempC
Min/Max:
Enabled
Status:
PVar:
Disabled
mV_pH
mV_ORP
TempF
pH
°C
Unit:
mV
°F
If PVar = "TempC"
If PVar = "TempF"
If PVar = "mV_pH" or "mV_ORP"
If PVar = "pH"
STATUS:
choose to display (choice “Enabled”) or not display (choice “Disabled”) the highest and lowest
measured values (of the measurable variable chosen in PVAR hereafter) since the latest reset or the power-up of
the device.
PVAR:
choose the measurable variable which highest and lowest measured values are displayed in the Process
level.
UNIT:
choose the preferred unit in which the lowest and highest measured values are displayed.
9.11.7 setting the display contrast and brightness
See chpt. 9.9 to access the Parameters menu.
On a device variant with a single M12 fixed connector and if the power supply is lower than 16 V, do not
increase the backlight over 14 %, to not influence the 4...20 mA current output.
Contrast
xx%
Backlight
xx%
Display
This is
when the
device is be-
ing parame-
tered............
....................
Param
This is
when the
device is be-
ing parame-
tered............
....................
→
Set each percentage using
and
.
CONTRAST
: Choose the display contrast level (as a %).
BACKLIGHT
: Choose the light intensity of the display (as a %).
These settings only affect the display module. They are not factored in during a device data UPLOAD. Refer to
chpt. 9.11.1.
English
Type 8202 ELEMENT
