Step 2:
2A.
Assemble Rear Left Riser with one of the two Rear Floor Brackets with a 3/8-16
UNC X 2.5, a lock washer and flat washer. Also assemble the Rear Right Riser with
the other Rear Floor Bracket.
2B.
Place the Rear Left Riser and the Rear Right Riser into the vehicle directly over
the 4 rear holes. Then place an M8x1.25 x 50 Hex head fastener with a 5/16 lock
washer and 5/16 flat washer into the 4 holes that are located nearest the back of the
vehicle as shown below. Vehicle floor is shown for reference in this step. See
Exploded View 1 for stack up.
Only tighten fasteners finger tight for now.
!
Exploded View 1
REAR LEFT
RISER
REAR RIGHT
RISER
2B
4X
1B
Repeat the same stack up on the
Rear Right Riser
REAR LEFT
RISER
REAR FLOOR
BRACKET
PRM-SERIES REDI RACK™
Page 9 of 15
©2016 Burco, Inc.
