12
TURN OFF THE POWER SUPPLY AND REMOVE THE PLUG WHEN NOT IN USE, BEFORE CLEANING, AND BEFORE
REPLACING ANY PARTS.
8.1 Filling
Important: Always put water in the unit before switching on.
1.
Lift out the bowl by the edges. Raising it off the upper section and sliding it up the water spout. When it is
high enough, rotate the bowl and spout until clear of the opening of the upper section.
2.
Lift out the waste container, remove the lid and check that it is empty.
Important: This container must be empty before use otherwise there is a chance of over filling.
3.
Replace the waste container in the top section and replace the bowl, ensure that
it is fitted snugly back in place.
4.
To fill, release the catches situated either side of the handwash that secure the
upper section to the lower.
5.
Lift the upper section until it is clear of the lower section noting two cut outs in
the bottom edge. These are to be positioned on the left-hand side of the rolled
edge of the lower container giving a resting position and allowing hands free
access for filling.
6.
Pour clean water into the lower tank. Never fill beyond the MAX fill mark (10
litre) otherwise water will flow out of the overflow.
7.
Lift the upper section and replace it on the lower section, aligning the two container seams. Failure to
correctly align these sections will result in difficulty in latching the two parts together and may damage
the latches themselves.
Summary of Contents for 111715
Page 23: ...23 17 0 Notes...
