Page 8
CLEANING
1. The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
2. Check and clean the sprayhead. The sprayhead holes must always remain open. Insert the short end of the
sprayhead cleaning tool into each of the fi ve water outlets of the plastic sprayhead to remove any mineral
deposits (Refer to Fig 1)
3. Insert the long end of sprayhead cleaning tool into the sprayhead fi tting, and rotate several times to remove
any mineral deposits from the fi tting (Refer to Fig 2).
NOTE:
In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer
and takes less than a minute.
NOTE:
In the event that the
"Brew Logic"
circuit activates (compensating for high lime build up), it will temporarily
disable the
"Recovery Booster"
and
"Pulse Brewing"
systems until the unit has been de-limed.
FIGURE 1
FIGURE 2
TANK DRAIN
1.
Loosen screws that secure the front access panel. Remove the panel.
2.
Unfasten the hose clamp at the end of the drain hose. Remove the plug.
3.
Place the end of the drain hose in a container that has a minimum capacity of 200 oz (5.9 L).
4.
Release the white clamp to drain water from the tank.
5.
When tank is empty, close the white clamp, replace the plug, and tighten the clamp at the end of the drain
hose. (Repeat steps 2-5 for remaining side on Twins)
6.
Replace the front panel and tighten screws.
39130.1 112008
